#Bearing isolator install#
#Bearing isolator free#

Reduce time to install without an arbor press with Garlock's patented Cam-Lock o-ring system.

Stationary o-ring contact between the seal and housing eliminates housing damage.

Stationary o-ring contact between the seals and shaft eliminates shaft grooving damage.

For more information, call (800) 447-0524 or visit Design offers the fastest mean time to repair (MTTR) during rebuilds This monthвЂ™s handy tips provided by David C. Also, bearing isolators do not require lubrication or any special shaft finish. As rotating equipment is routinely maintained and repaired, metal bearing isolators can be used over and over for many years. Most commonly made of bearing bronze, isolators are also made of stainless steel, titanium, and aluminum. In fact, the isolatorвЂ™s higher initial cost is often justified by its longer, more reliable life. In fact, some manufacturer warranties are extended with bearing isolators.ДЄ: Bearing isolators generally cost ten times as much as a common rubber lip seal, though the cost of installation is about the same. Now bearing isolators are used to permanently protect bearings in many types of rotating equipment, including process pumps, electric motors from 1вЃ„2 to 10,000 hp, gearboxes and mechanical drive steam turbines. First installed by pump and motor manufacturers as optional features, they later became standard equipment on higher-duty products. Q:Where are bearing isolators most appropriate?ДЄ: About 25 years ago, bearing isolators began replacing some lip seals in industrial pumps in various process industries. Due to the nature of their design, they are always taken out of service after failure and replaced, but not necessarily in kind. Whether spring or magnetically loaded, their failure is often abrupt and unpredictable. WhatвЂ™s more, all contact seals consume power - around 150 watts per contact surface - and cause heating of the lubricant and even the bearings.ДЇace seals have another challenging limitation. As the sealвЂ™s condition deteriorates it can groove the shaft, carbonize at points of contact with the shaft, and finally lose its ability to effectively seal the bearing enclosure. For example, in a typical setup a rubber lip seal with a maximum useful life of 3,000 hours - 4.1 months - might protect rolling element bearings with a design life rating exceeding 150,000 hours - 17 years. However, when worn seals arenвЂ™t promptly replaced, they compromise systems. TIR, shaft-to-bore misalignments to 0.007 in., and shaft surface speeds to 12,000 ft/min.ДЄ: Contact seals are also used to protect bearings. One representative isolator design can operate with a continuous temperature limit of -40В° to 400вЏ, shaft runout to 0.005 in.

#Bearing isolator free#

Some utilize a blocking feature that inhibits the free transfer of vapor contamination when the rotating equipment is cycled on and off. Isolators come in solid and split configurations and accommodate shaft diameters from 0.625 to 108 in.

The two halves interact through mating grooves so the rotor turns with a rotating shaft, while the stator is pressed into a bearing housing.

While bearing frequency harmonics and angular misalignment can separate traditional sealing systems, an isolatorвЂ™s rotor and stator are unitized so they donвЂ™t separate during use. Called an isolator, this component keeps contamination out and lubricant in bearing enclosures for non-contact protection. There is a mechanical alternative to regular rubber bearing seals.