#Battery cable splice how to
#Battery cable splice manual

#Battery cable splice how to

Need to test your solenoid? Check out our post on How To Test A Solenoid. If it is burned out, it must be replaced in addition to installing the new cable. NOTE: The positive cable may have a fusible link auxiliary lead. Properly position and tightenВ terminals on battery posts. Reconnect battery cablesВ to battery in reverse sequence of steps 2 and 3, connecting the battery cable wired to starter or solenoid first and the ground cable last. Repeat if thereвЂ™s an additional main cable. Insert stripped end of main cable into the battery cable repair splice, tighten locking hex screw with hex wrench and slide insulator sheath over splice connection. Insert the stripped end of auxiliary lead into appropriate butt splice and crimp using a crimping tool.В Repeat if there are additional auxiliary leads. Strip insulation with your cable stripper from remaining auxiliary lead 1/4вЂі and remaining main cable(s) 3/4вЂі. Cut the wires as close as possible to the old terminal. Remove old terminal that is to be replaced by cutting off the wires attached to it. This cable is the one wired to the starter or solenoid. The ground cable is the cable wired to the engine block, vehicle frame or other metallic ground.Дisconnect other cable from the battery. Locate and disconnect ground cable from the battery.

#Battery cable splice manual

NOTE: Before proceeding, consult your ownerвЂ™s manual or service specialist to determine if special procedures are required before disconnecting your battery.

Place automatic transmissions in вЂњPARKвЂќ(manual transmissions in вЂњNEUTRALвЂќ.) Turn off all electrical loads on vehicle. Hex Wrench (included in Del CityвЂ™s Battery Cable Repair Splices) Step 1 It is critical to follow all safety instructions, and to always wear safety glasses when working near batteries. IMPORTANT:Batteries produce explosive gases. Battery Cables LDOPTO 6 AWG 20-Inch Jumper Cables for Car Battery Inverter Cable Set with Terminals, Red + Black Tinned Copper Battery Inverter Cables for Automotive, Marine, Solar, ATV, Oxygen-Free 522 1099 Get it as soon as Thu, Jun 2 FREE Shipping on orders over 25 shipped by Amazon Only 14 left in stock - order soon. Remember, use a high temperature sleevingВ to protect againstВ heat and abrasion when necessary. Plus, even with the repair splice, youвЂ™ll still have an OEM style fit! Instead of replacing the entire harness, simply replace the damaged or corroded battery terminals. Quickly and conveniently repair cable harnesses with battery cable repair splices.